
10.1.6 Expansion card -ETHERCAT-
This section describes the EtherCat expansion card for SERVOSTAR 300.
Information on the range of functions and the software protocol can be found in the Ether
-
Cat documentation. This expansion cards enables the servo amplifier to be connected to
the EtherCat network.
10.1.6.1 Front view
10.1.6.2 LEDs
LED Function
ERROR
flickering = Booting Error
blinking = Invalid Configuration
single flash = Unsolicited State Change
double flash = Watchdog Timeout
off = No Error
RUN
on = Device is in state OPERATIONAL
blinking = Device is in state PRE-OPERATIONAL
single flash = Device is in state SAFE-OPERATIONAL
off = Device is in state INIT
ACT IN
on = linked, but not active at X20A (in)
flickering = linked and active at X20A (in)
off = not linked at X20A (in)
ACT OUT
on = linked, but not active at X20B (out)
flickering = linked and active at X20B (out)
off = not linked at X20B (out)
10.1.6.3 Connection diagram
SERVOSTAR
®
300 Product Manual 95
Kollmorgen 09/2006 Expansions and Accessories
Komentáře k této Příručce